Showing 31–45 of 62 results
This is the ring on the bottom of the cutting head that you push up on to compress the spring.
This Teflon Cover is mounted above a Mazak Standard Nozzle.
Located on the lower section of the nozzle body of the Non Contact Cutting Head on a Mark II or NTX.
This spring is located inside the lower nozzle body of the Cutting Head on the Hyper Gear, HTX, Mark III, and Optiplex.
This threaded aluminum ring holds the Copper Nozzle Holder and the Connector (M115B0) for the Short Sensor Cable (M116S0).
This Aluminum Body is only used on the original HTX and Hyper Gear non-servo torches.
This is the large Aluminum ring that the electrical connector (M508B0) is attached to.
This Connector Assembly is a fully assembled unit that the Short Sensor Cable (M116S0) threads onto.
Mazak Connector Screws 4pcs m2.5×4
This is an aluminum spacer under electrical connector for the sensor cable
This Copper Nozzle Holder is the piece that the nozzle threads into in the lower section of the nozzle body of the Non Contact Cutting Head on a Mark II or NTX.
These bolts hold the HG connector onto the Aluminum Ring.
This is the electrical connector that is bolted onto the Aluminum body (M506A0), the sensor cable is attached to it.
Mazak Nozzle Housing Dowel
This copper ring is the bottom piece in the lower section of the Non Contact Cutting Head on a Mark II or NTX.